- 1. Squeeze handle – After wrapping the load, squeeze the handle of the tool to lift the holding gripper
- 2. Threading – Thread the free end of the strap through the back of the tool, allowing approximately 3″ of overhang front the front of the tool.
- 3. Wrap the strap around the load
- 4. Threading – Take the end of the strap still attached to the coil and thread it through the cutter blade and the windlass
- 5. Tensioning – Use the tension handle to tighten reach the desired tension
- 6. Seal placement – Place the seal on both straps at the front of the tool
- 7. Open the sealer and engage the seal
- 8. Crimp the seal – Close the sealer and crimp the seal
- 9. Squeeze handle – Squeeze the handle, automatically cutting the strap
- 10. Cut strap
- 11. Remove tool by twisting to the right