How to use a Windlass Tensioner for Plastic Strapping

1. Squeeze handle – After wrapping the load, squeeze the handle of the tool to lift the holding gripper
squeezing handle of windlass tensioner

2. Threading – Thread the free end of the strap through the back of the tool, allowing approximately 3″ of overhang front the front of the tool.
threading for plastic strapping

3. Wrap the strap around the load
wrapping the strap around the package

4. Threading – Take the end of the strap still attached to the coil and thread it through the cutter blade and the windlass
how to strap a windlass tensioner

5. Tensioning – Use the tension handle to tighten reach the desired tension
plastic strapping with tensioner

6. Seal placement – Place the seal on both straps at the front of the tool
plastic strapping with tensioner

7. Open the sealer and engage the seal
plastic strapping with tensioner

8. Crimp the seal – Close the sealer and crimp the seal
plastic strapping with tensioner

9. Squeeze handle – Squeeze the handle, automatically cutting the strap
plastic strapping with tensioner

10. Cut strap
plastic strapping with tensioner

11. Remove tool by twisting to the right
plastic strapping with tensioner